and release agents. Polish the surface by using angle grinder with grain 80. Do not grind an indentation. Fig. 6: Polishing the surface with grinder ! ! ! ! ! Assembly instructions VOSSOBW501SG sensor, [...] temperature range of +10 °C to +30 °C (+50 °F to +86 °F). Provide the following materials/tools: angel grinder with grain 80, drilling machine with 60 and 120 grain, abrasive paper 120, abrasive paper 240, cleaning [...] machine with grain 120. Fig. 8: Polishing the surface using drilling machine with grain 120 Step 4 Grind the surface fine by hand by using abrasive paper with grain 120. This step should be performed on

tubes at right angles. An angle tolerance of ±1° is permissible. Do not use tube cutters or angle grinders to cut tubes. Slightly deburr tube end inside and outside. Clean the tube. max. ±1° 3 Flared cone

4 3.2 Cut tubes at right angles. An angle tolerance of ± 1° is permissible. Do not use a rotary grinder or tube cutter. 3.3 Deburr the inner and outer edges of the tube ends slightly and clean the tubing

2.2 Saw tube off at right angles. An angle tolerance of ± 1° is permissible. Do not use a rotary grinder or tube. 2.3 Slightly deburr tube ends inside and outside. Clean the tube. Attention! If tubes are

2.2 Saw tube off at right angles. An angle tolerance of ± 1° is permissible. Do not use a rotary grinder or tube cutter. 2.3 Slightly deburr tube ends inside and outside. Clean the tube. Attention! If tubes

tubes at right angles. An angle tolerance of ±1° is permissible. Do not use tube cutters or angle grinders to cut tubes. Deburr the inner and outer edges of the tube ends. For the couplings to fulfil their

tubing at right angles. An angle tolerance of ±1° is permissible. Do not use tube cutters or angle grinders to cut tubes. max. ±1° Series Tube OD [mm] s [mm] L1 [mm] L2 [mm] L3 approx. [mm] A1 [mm] R≥3xDN

tubes at right angles. An angle tolerance of ±1° is permissible. Do not use tube cutters or angle grinders to cut tubes. Minimum lengths for clamping in straight tubes. max. ±1° Series Tube OD [mm] s [mm]

and sell rejected computer chips to recyclers. For plastics, we separate specific material sprues, grind them and sell them to recyclers although the process is not actually cost efficient. Certain materials

and sell rejected computer chips to recyclers. For plastics, we separate specific material sprues, grind them and sell them to recyclers although the process is not actually cost efficient. Certain materials

manufacturer's or supplier's cut. An angle tolerance of ±1° is permissible. Do not use a rotary grinder or tube cutter. 2.3 Slightly deburr tube ends inside and outside. Clean the tube. Attention! If tubes [...] manufacturer's or supplier's cut. An angle tolerance of ±1° is permissible. Do not use a rotary grinder or tube cutter. 2.3 Slightly deburr tube ends inside and outside. Clean the tube. Attention! If tubes [...] manufacturer's or supplier's cut. An angle tolerance of ±1° is permissible. Do not use a rotary grinder or tube. 2.3 Slightly deburr tube ends inside and outside. Clean the tube. Attention! If tubes are

the pre-assembly devices regularly Select tubes as specified in DIN EN 10305-4. Do not use rotary grinder or tube cutter Only de-burr tube edges internally and externally, do not sharpen them. Check de-burring